Our work in Trumbull
We have completed 2 roofs in Trumbull. That figure comes from our own job records rather than an estimate, and it moves as we work. The town is 12 miles from Bethel.
Trumbull covers 23.2 square miles in Fairfield County.
Trumbull takes in Daniels Farm, Long Hill, Nichols, Ox Hill, Rock Raymond, Tashua and Trumbull Center. Age and construction of the housing changes between them, which is why we look before quoting.
Design criteria for a Trumbull roof
Roofs in Trumbull are designed to an ultimate wind speed of 120 mph, which the code expresses as 93 mph nominal. The source is Appendix AY of the 2022 Connecticut State Building Code. 147 of Connecticut's 169 municipalities are rated at or above that figure. It also falls within the hurricane-prone region, so a full tear-off here brings the sealed roof deck requirement with it.
Ground snow load in Trumbull is 30 psf. Baseline loading for the state, which puts the emphasis on eave detailing rather than on structure.
Connecticut amendments that apply here
The state changes the model code in two places worth knowing about. R905.1.2 requires ice barrier everywhere in Connecticut, extending at least 24 inches inside the exterior wall line as measured up the slope. And R905.1.1, the sealed roof deck amendment, does not apply over narrow lumber sheathing — under 3 inches nominal — which is exactly what many pre-1950 houses in this state have.
On nailing, be careful who you believe. Connecticut's code minimum is four nails per shingle. Six is what the shingle manufacturers require to keep a wind warranty in force, and six is what we install — but that is a manufacturer requirement, not a code requirement. A contractor telling you the code demands six is either mistaken or selling.
Permits and inspections in Trumbull
Roofing work in Trumbull is permitted through the town's building department. Full-time staffing means inspections here rarely become the bottleneck. The published number is 203-452-5020. Written questions go to rdunn@trumbull-ct.gov. We pull the permit as part of the job. No homeowner should be asked to pull their own roofing permit by a contractor working on their house.
A roof replacement permit in Connecticut is generally issued over the counter or online once the scope is submitted, with an inspection at completion. Where a house sits in a local historic district, or where zoning or health review applies, that approval comes first and can add real time. If your property is affected, we will tell you before the contract is signed rather than after the dumpster arrives.
How Trumbull compares with the towns around it
Trumbull shares its design wind figure with all 6 of its neighbours, so specifications carry across these town lines cleanly. The permit process does not — each town runs its own.
| Bordering town | Design wind | vs. Trumbull | Ground snow | County |
|---|---|---|---|---|
| Bridgeport | 120 mph | same | 30 psf | Fairfield |
| Easton | 120 mph | same | 30 psf | Fairfield |
| Fairfield | 120 mph | same | 30 psf | Fairfield |
| Monroe | 120 mph | same | 30 psf | Fairfield |
| Shelton | 120 mph | same | 30 psf | Fairfield |
| Stratford | 120 mph | same | 30 psf | Fairfield |
Get a straight answer on your roof
Free inspection, a written scope, and a 25-year workmanship warranty.
Common questions about roofing in Trumbull
Have you worked in Trumbull before?
Yes. Our records show 2 completed roofs in Trumbull. That count comes from our own job history.
What wind speed does a roof in Trumbull have to be designed for?
The 2022 Connecticut State Building Code assigns Trumbull an ultimate design wind speed of 120 mph. That figure sets the fastener schedule and the manufacturer wind rating we specify.
Is ice barrier required on a Trumbull roof?
Yes — Connecticut requires it statewide under code section R905.1.2, running from the lowest roof edge to at least 24 inches inside the exterior wall line. With a 30 psf ground snow load in Trumbull, that detail is doing real work.
Do I need a permit to replace a roof in Trumbull?
Yes. A roof replacement in Trumbull requires a building permit, and we pull it as part of the job. The building department's published number is 203-452-5020 if you want to confirm anything independently.
How many nails per shingle should be used in Trumbull?
Connecticut's code minimum is four. Shingle manufacturers require six to keep their wind warranty in force, and six is what we install. Six nails is a manufacturer requirement, not a code requirement.
Design criteria are taken from Appendix AY of the 2022 Connecticut State Building Code. Building department details come from the State of Connecticut list of municipal building officials, updated 04-06-2026. Municipal staffing and personnel change — confirm current details with the town. Stallion Ridge Exteriors is a service-area business based in Bethel, Connecticut.